Deionizer

Water Deionizer - HYDRO-PURE^®

The Hydro-Pure^® series deionizers offered two stages both co-flow and counter-flow deionizers for the applications in different industrial process. These systems are available in a versatile range of outputs from 1.0 m3/hr to 90 m3/hr.

The co-flow (HTS) range is developed to produce a cost-effective supply of good quality deionized water to meet a wide spectrum of customer needs. Particular emphasis has been placed on ease of operation, maintenance and service, plus features which enable users to easily check how the unit is performing.

The counter-flow (HCI) system is adopting an improved technique, which better water quality can be produced by these units. By using HCI system, a higher working capacity can be obtained from the ion exchange resin for a given regeneration level. Waste water is minimized, and the reduced volume of volume of water required during the regeneration cycle, together with the use of smaller effluent neutralization facilities, result in cost savings.

The range of Hydro-pure deionizers are skid mounted packaged units which are pressure tested and semi-commissioned before delivery. This considerably reduces installation time and the overall capital cost of plant.

Features Benefits Option

Designed for cost-effectiveness and efficiency in ion exchange.

Skid mounted Packaged Plant.

Co-flow or counter-flow regeneration

Simultaneous regeneration
Fully or semi-automatic.

Competitive capital & running cost.

Low installation cost and time.

Higher quality water or lower costs on different requirement.

Cut down the outage time and less storage space is required.

Reduced operator involvement.

Pre and post treatment.

Duplex configuration.

Effluent pH correction.

Sequential regeneration.

Manual and mixed bed unit.

Technical Data for Co-Flow Demineralizer (HTS)

Deioniser		Flowrate		Capacity	Regenerant		Plumbing		Space requirement			Work
Models		Min.	Max.	Max.	HCl 33%	NaOH 48%	Inlet	Outlet	Width	Depth	Height	Weight
Manual	Automatic	m³/hr	m³/hr	Kg as CaCO₃	Lits.	Lits.	mm	mm	mm	mm	mm	Kg
HTS250M	HTS250A	0.2	1.5	0.9	6	3.3	20	20	2500	600	2000	390
HTS300M	HTS300A	0.3	2.0	1.6	10	5.5	20	20	2500	600	2000	400
HTS400M	HTS400A	0.8	3.2	3.8	20	11	25	25	2700	700	2000	500
HTS500M	HTS500A	1.4	6.0	6.9	35	19	40	40	3400	800	2000	880
HTS600M	HTS600A	2.4	9.0	11.5	59	32	40	40	4000	900	3000	1200
HTS750M	HTS750A	4.0	15.0	19.0	98	54	50	50	4500	1100	3000	2085
HTS900M	HTS900A	5.6	22.0	26.5	137	75	50	50	4700	1200	3000	2590
HTS1100M	HTS1100A	7.0	30.0	50.2	260	143	50	50	5200	1500	3000	3330

Technical Data for Counter-Flow Demineralizer (HCI)

Deioniser		Flowrate		Capacity	Regenerant		Plumbing		Space requirement			Work
Models		Min.	Max.	Max.	HCl 33%	NaOH 48%	Inlet	Outlet	Width	Depth	Height	Weight
Manual	Automatic	m³/hr	m³/hr	Kg as CaCO₃	Lits.	Lits.	mm	mm	mm	mm	mm	Kg
N/A	HCI250	0.2	1.5	0.9	6	3.3	20	20	2500	600	2000	390
N/A	HCI300	0.3	2.0	1.6	10	5.5	20	20	2500	600	2000	400
N/A	HCI400	0.8	4.0	3.8	20	11	25	25	2700	700	2000	500
N/A	HCI500	1.4	6.0	6.9	34	18.5	40	40	3400	800	2000	880
N/A	HCI600	2.4	10.0	11.5	51	28	40	40	4000	900	3000	1200
N/A	HCI750	4.0	15.0	19.0	83	47	50	50	4500	1100	3000	2085
N/A	HCI900	5.6	20.0	26.5	114	64	50	50	4700	1200	3000	2590
N/A	HCI1100	7.0	27.0	50.2	234	129	50	50	5200	1500	3000	3330
N/A	HSC3500	30.0	35.0	16.0	70	42	80	80	2390	1550	2790	2500
N/A	HSC5000	45.0	50.0	23.0	103	61	80	80	2390	1550	2840	2600
N/A	HSC7000	60.0	70.0	32.0	142	84	100	100	2960	1730	2870	3100
N/A	HSC9000	80.0	90.0	42.5	189	112	100	100	2960	1730	2940	3200

Specification			Client to Provide :
Treated water quality	Conductivity (micro S/cm)	Silica (ppm)	Power supply for automatic models 240 VAC / 415 VAC , 50 Hz Air supply at 5 -7 bar, 6-10 l/m intermittent Raw water, treated water and drain pipework to and from the unit Booster / pressure reducing system if pressure not within the range
TS	<10	0.2
HCI	2 av.	0.2
HSC	2 av.	0.2
Vessel	FRP with Vinylester lining
Controller	PLC
Pipework	PVC

Information contained herein is subjected to change without notice